Quartz tube water cooling flange vacuum hot pressing sintering furnace

Vacuum Heated Pressing Furnace up to 1100ºC with 4"Quartz Tube and Water Cold Flange - OTF-1200X-VHP4    The OTF-1200X-VHP4 is designed for making dense compound materials under both vacuum & high pressure, and/or bounding multi-layer wafer together under a pressure up to 5 metric tons. &n

Featured Products

Vacuum Heated Pressing Furnace up to 1100ºC with 4"Quartz Tube and Water Cold Flange - OTF-1200X-VHP4   
 
The OTF-1200X-VHP4 is designed for making dense compound materials under both vacuum & high pressure, and/or bounding multi-layer wafer together under a pressure up to 5 metric tons.    It is integrated with  split vertical tube furnace with a vacuum-sealed 4" quartz tube and  40T electric hydraulic press, as well as one sets of 0.5" ID  graphite pressing die.   The furnace can be heated up to 1100ºC using a temperature controller with 30 programmable segments. Water cooled flanges facilitates a vacuum level up to 10E^-5 torr via use of a turbomolecular pump.
 
Specification:
 
Max. Pressure
 
6 metric tons ( 10 MPa on pressure gauge ) limited by 0.5" graphite pressing die
Warning:   Higher pressure  may damage 0.5" die.  If you may higher pressure , please contact us to reduce ID of pressure die
Hydraulic  Pump
 
Built in electric hydraulic pump with Max. load capability of 40 metric tons.
Cylinder size 25 mm in diameter.
Movable distance: 15mm
Automatic max. pressure controller
Vertical Furnace
 
 
Splitable vertical furnace heated by Ni-Cr-Al resistance wire
Max. working Temp>           1200oc < 60 minutes
Continuous working temp:    1150oC
Max. Heating Rate:            < 10oC/minute
Heating zone length: 12" ( 300mm )
30 segment programmable controller with +/-1ºC accuracy
RS485 port installed for remote PC operation
Power consumption: 2200W
Power input: 208 - 240VAC, 50/60 Hz single phase
Quartz Tube & Sealing FlangeOne quartz tube 100 OD x 94 IDx 640L mm (4" x 25") is included 
Water cooled flanges are installed on two ends of tube with KF-25D vacuum port & pressure gauge as well as a 1/4" gas inlet port with SS needle valve
 12L/minute water flow is required, using a recirculating water chiller to save water
Max. achievable vacuum level: 10E^-5 torr by molecular pump
High Temperature Pressing Die Set (Optional)Two graphite pushing rods are built in. ( bottom left picture )
One set of 0.5" ID  graphite die are included for immediate use.
The high temperature die kit is usually made of high purity graphite with max. working pressure of 50 MPa
The graphite pressing die gets broken easily and is consumable,
 
Mica spacers are used to adjust the height of die sets (while providing heat insulation).
Dimensions1050mm(L) x 750mm(W) x 1750mm(H) 
Net Weight 365 kg  
Weight of Shipment 
& Dimension
450kg
48"x40"x83"
 WarrantyOne year limited standard warranty 

Contact us

Please feel free to give your inquiry in the form below We will reply you in 24 hours